Profile™ Compact Dryers. Dryer shall be surface mounted one piece aluminum 7/64" (2.6 mm) thick. The cover shall be finished with an epoxy paint finish. The surface mounted dryer shall not protrude more than 4" (102mm) from the wall and shall comply with ADAAG requirements. The motor shall be a 1/4 HP 7500 RPM brush type with dual sealed ball bearings. The dryers hall have two blower housings, a fan, and a totally enclosed heating element. The unit shall send 180 cubic feet per minute of 140˚F (60˚C) air through a tamper-resistant air exit and be protected by an automatic resetting thermal protection device. The unit shall have hands-free automatic stop/start infrared circuitry and self-adjusting time-out and fail-safe "off" protection. The entire unit shall be internally grounded and shall have universal voltage circuitry allowing it to operate at input voltages of 100 to 240 Vac-50/60 Hz. It shall be UL, CSA, and CE listed.