SPECIFICATIONS:

All grab bars are fabricated of satin finish 18 gauge type 304 stainless steel tubing. Mandrel bending process ensures uniform bar diameters. Bars pass through flanges and are heliarc welded to form a single structural unit. Bars with 1 1⁄2" (38 mm) clearance from wall can support loads in excess of 900 lbs. (408 kg) when properly installed complying with structural strength requirements of ADA Guidelines.

SNAP FLANGE

Click on Product Picture

CONCEALED MOUNTING

Click on Product Picture

EXPOSED MOUNTING

Click on Product Picture

Snap Flange

3700 Series — 1 1⁄4" (32 mm) o.d.
3800 Series — 1 1⁄2" (38 mm) o.d.

• Cover snaps over mounting flange
dimples to conceal screws.
• Concealed mounting flange is 3 1⁄8" (79 mm) o.d.diameter with two screw holes and three locking dimples and is 1⁄8" (3 mm) thick, type 304 stainless steel.
• Cover is type 304 stainless steel with satin finish, 22 gauge, 3 3⁄16" (81 mm) diameter.

Concealed Mounting

3100 Series — 1 1⁄4" (32 mm) o.d.
3200 Series — 1 1⁄2" (38 mm) o.d.

• Flange is 3" (76 mm) diameter, 1⁄2" (13 mm) deep, 11 gauge type 304 stainless steel with satin finish.
• Tenon plate is 13 gauge with slotted screw holes.
• Flange is secured to concealed tenon plate with 3 stainless steel allen head screws.

Exposed Mounting

3400 Series — 1 1⁄4" (32 mm) o.d.
3500 Series — 1 1⁄2" (38 mm) o.d.

• Flange is 3" (76 mm) diameter, 1⁄8" (3 mm) thick type 304 stainless steel with a satin finish.
• Exposed mounting screw holes are drilled and countersunk.

Designers Note:
For a non-slip surface, specify suffix “P" (peened).
When specifying grab bars insert the configuration type numbers on page 29 (of the catalog) into the double zeros at the end of the grab bar series number.
Example 1:
A 1 1⁄2" (38 mm) concealed 18 " x 133 " (457 x 838 mm) horizontal grab bar has a model number — 3274. When a special size is needed add suffix “M" plus the size.
Example 2:
A 1 1⁄2" (38 mm) concealed 23" x 37" (585 x 940 mm) horizontal grab bar has a model number 3274-M2337.